Doesn't it look great out front?
What you need:
- Old Boards, Barn boards or 1 X 6's
- Scrap wood- plywood works well
- Acrylic paint
- Paper towel
- Brushes in various sizes
- Polyurethane stain
1. Layout your boards in your desired format. I decided I wanted a horizontal sign, approximately 3 feet by 3 feet to fit on the side wall of our home. I measured each board so it was approximatly 3 feet in length then trimmed the edges. As you can see the edges of my sign are in no way perfect, this adds to its rustic charm.
2. Choose which side you think is best for the front. Once confirmed, turn them all over good side down.
3. Take some scrap wood, like a few strips of ply wood and place them vertically close to each edge of your sign to use like a bracket for hanging afterwords. These will be used for hanging it later and attaches the horizontal boards together, the longer your sign the more support boards you'll need. Cut them so they won't show past the sign and then add screws down each length to attach the barn board.
4. I did a smaller heart drawing here as a sample. Roughly sketch out your drawing in my case I wanted a 'W' to act as our family monogram. I googled some font styles I like and free hand drew the W, again it's not perfect but looks great from far away. Using a pencil press firmly to make the outline. Here I drew a small heart.
7. Time to antique it. I used black acrylic paint. I took my brush and did a really thin black line around some but not all of my design, as I went I used a damp paper towel and blotted and rubbed the black off a bit as I went. Here's a sample with the white heart design.
You'll end up with something like this:
Let's be honest, this is in no way a perfect outline, but from far it's going to look rustic and like it's been bleached by the sun for decades.
8. Give your sign a few coats of clear stain so your acrylic paint doesn't wash off in the next rain storm. I like the Minwax Fast-Drying Polyurethane spray in a can, it's really easy to use & you don't get the mess of cleaning up brushes afterwards.
9. Lastly time to hang, my hubby used a pretty heavy duty hammer drill to drill a few screws through the front of the sign but where the 2X4's where attached to hang to our brick wall, it's not going anywhere.
What do you think? I love it and it looks great with my perennial garden. We live near the beach so it especially fits in I think.